Upsizing Whitewash City

Okay. Forget what Eric recommends about upsizing via photocopier. It doesn’t work to upsize to 1/35.

I tried upsizing the last page of Out Buildings set (the one labeled Sheds & Privies). It did indeed upsize the width by 129% and the length by 155% as we figured it would based on the math instead of the 171% we need. This makes all the doors on the buildings about shoulder high and of varying widths depending on which way they were oriented on the page. It may still be usable for small sheds but will look odd next to a figure.

So I will have to upsize each building by hand. This is not a huge issue, but it would have been nice to quickly print out the textured pictures. I might still be able to scan them and manipulate them at home to print out at the proper size.

With the walkway, the Imperial Saloon will be a bit over 40cm long (a bit over a foot). This will make it a bit tight to lay out a town, even on a 4’ x 8’ table. Unless we set up the buildings oriented with the long side – which would make a smaller town - which should both work and be pretty accurate.